 |
 |
|
|
 |
On
any machine run top, the back splash will stop 3 1/4
" short of the end on a 27" bar.
|
|
 |
On
any machine run top, the back splash will stop 12
1/4 " short of the end on a 36" bar.
|
|
 |
When
measuring for a diagonal corner cabinet, measure from
wall to opposite side front corner. These dimensions
are often different as out of square walls and out
of square cabinets will affect these measurements.
Please
send cabinet measurments.
|
|
 |
Countertops
for diagonal corner cabinets are available only in
Tearform and Dunhill. The pie cut miter on machine
run tops causes too many seams to be safe from water
damage, or to be visually appealing.
|
|
 |
When
measuring for a Base End Cabinet, measure overall
cabinet length, and diagonal dimension of cabinet.
In addition, point dimensions are often helpful in
the event that "BEC" is not square.
|
|
 |
MKD
will add appropriate overhangs as requested.
|
|
 |
When
measuring any L-shaped or U-shaped countertop, measure
36" up one wall, and 48" up another wall.
Then measure point to point. If your walls are square,
this measurement will be 60". If this measurement
is more then 1/8" off, label your countertop
accordingly and MKD will build that top to fit your
walls.
|
 |
When
measuring for a 36" bar, add 10 5/8"
to cabinet measurement to insure proper overhang.
|
|
 |
When
measuring for a 27" bar, add 1 5/8"
to cabinet measurement to insure proper overhang.
|
|
 |
A
1 12" radius on a Curvform, Postform or
180 degree Wrap top shortens the front edge
of the top by 3/4". A 3" radius will
shorten the front edge by 1 1/2", etc.
|
|
|
| *MKD
is one of the few companies in the world that can manufacture
a radius corner with a bevel in the radius. |
|
|
